VSR

[Pat]

hey,

ive got a vsr-10 pro sniper here that im looking to upgrade at christmas..

does anyone know an easy way to take apart the cylinder??

im planning on putting a new spring, piston and spring guide in and i want to know an easier way than this: http://www.airsoftforum.com/board/VSR-C ... 39751.html

i dont have the tools required to do this method and i was wondering if anyone else had any ideas...

[slayer]

sorry man only way I know of is to drill out the pin

[Omega]

I agree with Slayer here, I have looked into the whole VSR-10 job and the only way to get into the cylinder from stock is by drilling that pin out.

Technically, not all the way out, just like 3mm so you can rotate the cylinder head, that's about it.

[kuku]

If it is a Marui, alot if work, you also need to seal the hopup unit

if it is a clone, much more easiler

[Pat]

yes its a marui... bought it from battlesoft actually, which i believe is owned by someone on this forum.
but anyway, i might just have to buy a new cylinder and saw open the other ****er to get out the parts i need that im not buying replacements for haha

[SkruWD]

or get a teflon cylinder hahaha those things cost your first born son

[kuku]

dang, cost me a lot to upgrade my Marui one, now on 0.2 around 420FPS.....0.3 only 360FPS ...... really should just buy a clone one, come with 450FPS and reallllllllllllllllllly cheap.

[Pat]

yeah im gona take mine up to 500FPS with 0.2g

im just gona get a new spring, teflon cylinder, and a shiny new cylinder head and saw the other thing open... seems like the only thing i can do with the tools ive got access to..

[slayer]

I did mine with a drill bit and a battery drill